Toho-electronics TTM-P9 Manual do Utilizador descarregar pdf (Página 8)

6.2 Detailed description of modes

① Reset mode

- This mode will stop control. (The system becomes this mode when the power is turned on.)

② Operation mode

- This mode will conduct programmed run control. (The RUN lamp lights.)

- The SV display will blink while a wait operation is in process in the wait zone or wait time.

- After a patterned operation is complete, the SV display will display "

'()

" and stop the control. The PV

display will display the current temperature.

- Holding the ▽ key down for 3 seconds during operation will enable step feed.

③ Pause mode

- This mode will pause programmed run control. (The RUN lamp blinks.) It will stop the time and maintain

the control temperature measured at that point in time.

④ Pattern number setting mode

- This mode will set the pattern number of the program to be executed.

- Use the △ and ▽ keys to set a pattern number.

- When the system shifted from "operation mode," holding the ▽ key down for 3 seconds will enable step

feed.

- When the system shifted from "operation mode," pressing the PATT./STEP key will display the time elapsed

and time setting.

PV screen: time elapsed, SV screen: time setting

- Pressing the △ and ▽ simultaneously while holding down the PATT./STEP will turn on all the indicators.

PV: Displays the pattern number selection

character.

SV: Displays the pattern number setting.

Lamp: Turns on the SET lamp.

PV: Displays the pattern number being executed

or the time elapsed.

SV: Displays the step number being executed or

the time setting.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Toho-electronics TTM-P9 Manual do Utilizador Página 8